Description

2011-2017 Chevrolet  Buick GMC Ecotec 2.4L L4. Vin Code K Federal Emissions Only with no smog holes by exhaust manifold

This Engine comes with the following components:

• Engine Long Block With Head installed
• Oil Pan
• Timing Cover
• Valve Cover
• Finishing Gaskets

Engine Assembly Numbers:

• LEA 
• MH7
• MHC
• NT7
• NU5

This engine Fits the following Vehicles:

• 2011-2017 GMC Terrain C  Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2012-2015 Chevrolet Captiva Sport K Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2012-2017 Buick Verano K Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2011-2016 Buick Lacrosse C Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2011-2012 Buick Regal R Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2012-2017 Buick Regal C Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2011-2017Chevrolet Equinox C Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2012-2014 Chevrolet Orlando M Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2013-2014 Chevrolet Malibu R Federal Emission Vehicle only No Smog Holes 2.4L Engine
• 2014 Chevrolet Impala R Federal Emission Vehicle only No Smog Holes 2.4L Engine

Engine Installation Warning :

Warning these engines are prone to failure due to the catalytic converters clogging up which overheat the engine damaging the head gasket amongst other things. Failures involving overheat are not covered under the warranty so please be sure your mechanic has diagnosed why your original engine failed properly. In the event the cause was overheating it is likely because of this and the catalytic converter should be replaced.

Every engine we sell is fully remanufactured to meet or exceed OEM specifications:

• Deep Clean – To start the remanufacturing process, every engine is fully disassembled and hot tanked (cast iron) or thermally cleaned (aluminum)
• Inspection – Magnaflux testing uses magnetic particles to inspect metal, checking for microscopic cracks and fissures that will cause long-term failure. All parts are visually inspected as well.
• Machining and New Parts – Deck surfaces are CNC machined and new parts are added. New parts inlcude bearings, pistons, rings, lifters, oil pump, gaskets, Viton™ valve seals, freeze plugs, galley plugs and either a new timing chain (with new tensioners) or a new timing belt (with new tensioner). If an engine has a timing-driven water pump, a new pump is installed.
• SIM Testing – Each engine is SIM tested after reassembly, with the cooling and oil systems being fully pressurized and the crank being spun at high RPM to verify compression and build quality.

Because of our rigorous remanufacturing process, we can offer the industry’s best warranties. Each engine comes with up to 7 years and 1 million miles of warranty, which can be upgraded to include Pure Care™ no-fault protection. No other engine manufacturer comes close.